build diary
<< | show individual entries | >>September 26, 2005: 
Setting up my own louvres.
This is a simple trick to find the middle of a panel. Run tape from one side to the other, then fold it back until the end reaches the start. Idiot proof and much easier than trying to measure.
entry 1013
If you squint, this looks like louvres.
Doesn't it? Well, once the holes are punched it will.
entry 1014
Caterham bracing at the front of the car.
Holy cow, there are tubes everywhere.
entry 1015
Caterham front control arms.
Clean and very simple.
entry 1016
Winner of the "Caterham I most want to take home" award.
An orange R300. Oooooo.
entry 1017
How do you fit two weeks worth of luggage in a Seven? Well, maybe "in" isn't the correct term.
entry 1018
All hotel parking lots should look like this.
With 50+ cars, it was impossible to get more than a small fraction in a photograph.
entry 1019
Three Sevens, a Miata and some fantastic roads.
Shortly after I took this picture, the Sevens disappeared into the distance.
entry 1020
September 27, 2005:
The Se7ens are coming!
The group should be trickling in to town today. One car has already partially arrived in the form of a damaged head. It should be sorted out tomorrow. I also have a thermostat coming for an R300 that's having trouble. Always an adventure!
Some scrambling around yesterday and the hood is now punched with louvres! I had to change the layout a bit because the spacing between the louvres was different than I had assumed. These are hot rod louvres and they're bigger than the ones used by the Seven makers. Still, the layout looks good - except for one small detail. It turns out that hot rods put their louvres facing forwards (why?). Those who know something about aerodynamics put them facing backwards. Well, these were punched by a hot rodder so they're backwards. I just never thought to specify even though we were laughing about how it was important to get them the correct way around. The problem that both of use considered the "correct way" to be different. This will work fine at a walking pace, but at speed it'll actually make the airflow worse than before. I'm going to be very embarassed showing up amongst the Se7ens this afternoon with a backwards hood. Kent, the guy who did the work, has bought a new piece of aluminum so I can fabricate another hood. I'll have to work fast, I'd like to have the proper setup for the race this weekend and definitely for the high-speed trackday at Aspen on the 15th. I also have to change the brakes on two cars. It's going to be a long week. Oh well, if it was easy everyone would do it...
entry 1021
Whoops.
The louvres look good, but they're the wrong way around. There's also a misalignment in two of the center groups. I'll be busy trying to duplicate this hood late at night this week.
entry 1022
September 28, 2005:
Anyone near Moab this morning would have seen a very dirty orange Seven roaring out of town at about 7:30.
I'd accidentally stayed the night. But let's backtrack.
The Se7en tour group hit their first rain on the way out of Vail. Not just a little bit of English drizzle, a full-on Colorado thunderstorm. Some were able to dodge the weather, others were not. By the time they started to roll into the Sonic drive-in in Grand Junction, everyone was at least a little damp. The appearance of all the little cars caused a bit of consternation in GJ and from the reaction of the Se7en drivers, none of the questions were new ones. To my surprise a number of the Se7en owners recognised my car! That was flattering.
I was planning on running through the Colorado National Monument with a group and then on to Moab. A couple of drivers wanted to borrow the Flyin' Miata garage in order to do a little work on their cars so we stopped by there first. It became obvious that I was distracted by the gorgeous car on the lift so the group took off, leaving about 4 Se7ens hanging around the shop. While one Duratec car got a new thermostat, I watched as Mike changed the oil on his car. His car has a massively powerful RST V8 underhood and has been modified in just about every possible way - you can see a number of photos of it on the RST website. Everything went well until he started refilling the dry sump tank and fresh oil started leaking out of a fitting. The suction pipe for the dry sump had to undergo some strange contortions and a custom fitting had cracked. We headed off to a hydraulic store, picked up a couple of pieces then started heating, bending and welding. By 5:30 or so we had a replacement fitting and the car was happy and leakproof once again. Mike and I were the only ones left so we took off to Moab under ugly skies. He has no windscreen and was wearing a helmet. I had a windscreen but no wipers. Not a good pair.
The route in to Moab is one of my favourites. Well, usually. Earlier rain had washed some of Moab's signature red dirt on to the road and turned it into snot. All we could do was just aim the cars straight and let them surf through. It was getting dark enough that a bit of local knowledge of the road helped considerably. By the time we arrived in Moab, the cars were totally encrusted in dirt. Mike offered to buy me dinner in exchange for the fun I had playing on his car, so a group of us went out in a pickup leaving the Se7ens behind.
We got back and there was lightning everywhere. A group of the drivers were standing under the car port in front of reception where I'd left my car and it was obvious that truly massive amounts of rain was falling all around. A number of folks offered me space in their rooms so I ended up crashing with Ben from Rocky Mountain Sports Cars. While we were hanging out in the lobby and talking about cars (really!), the rainstorm outside turned completely biblical in proportion. The decision to stay was a good one!
After a dry early morning run home, I was able to vibrate in to work. It's too bad I had to leave the group as they're a fun bunch and have some great days ahead of them. Maybe I'll have to head over to Europe for one of their tours someday.
So, what have I decided I "need" to do after looking at these cars? A lower windscreen for sure. Possibly some sort of different front suspension setup as well - I love the clean, light design of the Caterham control amrs but my shocks are not the right dimensions. They'd work as a pushrod setup, though. That would be sexy and might not cost much more than putting on 500 lb springs like Heikki has done. I might also run a smaller radiator to lighten the front end because my cooling system is total overkill right now. Another suggestion was to cover my exposed timing belt given the amount of debris that ricochets around the engine bay - good plan. Also some more bracing for the front suspension. Heck, maybe just cut the nose of the car off and re-engineer that whole thing!
I have to say the group was extremely welcoming to my weird little one-off car. They were really interested in the Miata engine and it was thoroughly inspected by everyone who got a chance - some of the underhood wiring that resulted from the throttle body swap was embarassing! Even Ben from Rocky Mountain was welcoming despite my cut-price version of one of their cars, consistent with how he and Nathan have treated me since I started this project.
entry 1023
Se7ens invade the Sonic!
entry 1024
Se7ens descend on the FM shop for various fettling.
entry 1025
Caterham art by Simon Bell.
The blank canvas can be seen in the previous picture.
entry 1026
Mike in his RST V8 Caterham after enjoying the roads in Moab.
Paved roads.
entry 1027
The Seven meets a Caterham SV!
They look more alike than I had expected. Yes Eric, I really need to make a grille.
entry 1028
Seven and SV from the rear.
entry 1029
The most obvious difference between my car and a Caterham is the placement of the scuttle.
The steering wheel is in approximately the same place on both cars. This explains why my engine appears so much further back than the Caterhams and why a Caterham shift knob always appears to be so far forward. Due to the rearward placement, the scuttle is wider and this is one reason my windshield looks tall. Despite appearances, the wheelbase is almost identical.
entry 1030
The result of driving to and from Moab.
My poor car. Remember how shiny and nice it looked a year ago?
entry 1031
The world's first adobe roll bar.
entry 1032
September 29, 2005:
I cleaned the Seven off last night.
Cloth seats are not a good idea in a car with no weather protection. Yuk.
entry 1033